//bottom ads

Volvo 240/740/760/780/940/960 1990-1998

Control Panel

Print

REMOVAL & INSTALLATION



Manual Control Head
240 Series AND COUPE
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the soundproofing and side panels from both sides of the center dash console.
  4.  
  5. Remove the radio assembly.
  6.  
  7. Remove the center control panel. Position the control assembly as far forward as possible.
  8.  
  9. Remove the lever knob, then detach the cable from the lever and control assembly.
  10.  

To install:
  1. Attach the cable to the control panel assembly.
  2.  
  3. Install the center control panel.
  4.  
  5. Install the knob.
  6.  
  7. Verify the cable operation.
  8.  
  9. Adjust the cable, as necessary.
  10.  
  11. Install the radio.
  12.  
  13. Install the soundproofing and side panels.
  14.  
  15. Connect the negative battery cable.
  16.  
  17. Check the system for proper operation.
  18.  

EXCEPT 240 SERIES AND COUPE
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the trim panel.
  4.  
  5. Remove the control assembly from the dashboard.
  6.  
  7. Disconnect the control cable clip, vacuum connections and electrical connections.
  8.  

To install:
  1. Attach the cable to the control panel assembly.
  2.  
  3. Secure the vacuum and electrical connections.
  4.  
  5. Install the center control panel.
  6.  
  7. Verify the cable operation.
  8.  
  9. Adjust the cable, as necessary.
  10.  
  11. Install the trim panel.
  12.  
  13. Connect the negative battery cable.
  14.  
  15. Check the system for proper operation.
  16.  

Electronic Control Head

See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the control knobs.
  4.  
  5. Remove the panel retaining screws.
  6.  
  7. Pull the panel out and unplug the electrical connectors.
  8.  
  9. Remove the panel from the dashboard.
  10.  

To install:
  1. Plug in the electrical connectors.
  2.  
  3. Position the panel in place and install the retaining screws.
  4.  
  5. Push the knobs onto the shafts.
  6.  
  7. Reconnect the negative battery cable.
  8.  
  9. Check the system for proper operation.
  10.  



Click image to see an enlarged view

Fig. Fig. 1: Exploded view of an electronic control panel assembly

 
label.common.footer.alt.autozoneLogo