Volvo 240/740/760/780/940/960 1990-1998

Shift Handle

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Raise and safely support the vehicle on jackstands.
  4.  
  5. From under the vehicle:
    1. Loosen the setscrew and drive out the pin for the shifter rod.
    2.  
    3. Disconnect the shift lever from the rod.
    4.  

  6.  
  7. From inside the vehicle:
    1. Pull up the shift boot.
    2.  
    3. Remove the fork for the Reverse gear detent.
    4.  
    5. Remove the snapring and lift up the shifter.
    6.  
    7. If overdrive-equipped, disconnect the engaging switch wire.
    8.  

  8.  

To install:
  1. If equipped, connect the overdrive switch.
  2.  
  3. Install the shifter and install the snapring.
  4.  
  5. Install the fork for the Reverse gear detent.
  6.  
  7. Install the shift boot.
  8.  
  9. From under the vehicle:
    1. Connect the shift lever rod.
    2.  
    3. Install the pin and setscrew.
    4.  

  10.  
  11. Lower the vehicle.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo