Volvo Cars 1999-05

Transmission Removal & Installation

Print

Rear Wheel Drive



  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Drain the transmission fluid.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Throttle Valve (TV) cable
     
    Oil dipstick tube
     
    Shift control and reaction rods
     
    Driveshaft
     
    Exhaust front pipe
     
    Starter motor
     
    Transmission crossmember and support the transmission with a jack
     
    Flywheel access cover
     
    Torque converter
     
    Transmission oil cooler lines
     
    Transmission flange bolts
     
    Transmission
     

  6.  

To install:

  1. Install or connect the following:

    Transmission and tighten the flange bolts to 65 ft. lbs. (85 Nm)
     
    Transmission oil cooler lines
     
    Torque converter and tighten the bolts to 32 ft. lbs. (42 Nm)
     
    Flywheel access cover
     
    Transmission crossmember and support the transmission with a jack
     
    Starter motor
     
    Exhaust front pipe
     
    Driveshaft
     
    Shift control and reaction rods
     
    Oil dipstick tube
     
    TV cable
     
    Negative battery cable
     

  2.  
  3. Fill the transmission to the correct level.
  4.  
  5. Start the engine and check for leaks.
  6.  

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Drain the transmission fluid.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Throttle Valve (TV) cable
     
    Oil dipstick tube
     
    Shift control and reaction rods
     
    Driveshaft
     
    Exhaust front pipe
     
    Starter motor
     
    Transmission crossmember and support the transmission with a jack
     
    Flywheel access cover
     
    Torque converter
     
    Transmission oil cooler lines
     
    Transmission flange bolts
     
    Transmission
     

  6.  

To install:

  1. Install or connect the following:

    Transmission and tighten the flange bolts to 65 ft. lbs. (85 Nm)
     
    Transmission oil cooler lines
     
    Torque converter and tighten the bolts to 32 ft. lbs. (42 Nm)
     
    Flywheel access cover
     
    Transmission crossmember and support the transmission with a jack
     
    Starter motor
     
    Exhaust front pipe
     
    Driveshaft
     
    Shift control and reaction rods
     
    Oil dipstick tube
     
    Throttle Valve (TV) cable
     
    Negative battery cable
     

  2.  
  3. Fill the transmission to the correct level.
  4.  
  5. Start the engine and check for leaks.
  6.  

 
label.common.footer.alt.autozoneLogo