Volvo Cars 1999-05

Transmission Removal & Installation

Print

Rear Wheel Drive



  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Drain the transmission fluid.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Reverse light connector at the firewall
     
    Shift linkage
     
    Gearshift boot
     
    Reverse detent fork
     
    Overdrive switch connector, if equipped
     
    Clutch slave cylinder
     
    Exhaust front pipe bracket
     
    Driveshaft
     
    Speedometer cable
     
    Starter motor
     
    Transmission crossmember and support the transmission with a jack
     
    Transmission flange bolts
     
    Transmission
     

  6.  

To install:

  1. Install or connect the following:

    Transmission and tighten the flange bolts to 30 ft. lbs. (40 Nm)
     
    Transmission crossmember
     
    Starter motor
     
    Speedometer cable
     
    Driveshaft
     
    Exhaust front pipe bracket
     
    Clutch slave cylinder
     
    Overdrive switch connector, if equipped
     
    Reverse detent fork
     
    Gearshift boot
     
    Shift linkage
     
    Reverse light connector at the firewall
     
    Negative battery cable
     

  2.  
  3. Fill the transmission to the correct level.
  4.  

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Drain the transmission fluid.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Reverse light connector at the firewall
     
    Shift linkage
     
    Gearshift boot
     
    Reverse detent fork
     
    Overdrive switch connector, if equipped
     
    Clutch slave cylinder
     
    Exhaust front pipe bracket
     
    Driveshaft
     
    Speedometer cable
     
    Starter motor
     
    Transmission crossmember and support the transmission with a jack
     
    Transmission flange bolts
     
    Transmission
     

  6.  

To install:

  1. Install or connect the following:

    Transmission and tighten the flange bolts to 30 ft. lbs. (40 Nm)
     
    Transmission crossmember
     
    Starter motor
     
    Speedometer cable
     
    Driveshaft
     
    Exhaust front pipe bracket
     
    Clutch slave cylinder
     
    Overdrive switch connector, if equipped
     
    Reverse detent fork
     
    Gearshift boot
     
    Shift linkage
     
    Reverse light connector at the firewall
     
    Negative battery cable
     

  2.  
  3. Fill the transmission to the correct level.
  4.  

 
label.common.footer.alt.autozoneLogo