The rear axle is a special type of transmission that reduces the speed of the drive from the engine and transmission and divides the power to the rear wheels. Power enters the rear axle from the driveshaft via the companion flange.The flange is mounted on the drive pinion shaft. The drive pinion shaft and gear which carry the power into the differential turn at engine speed. The gear on the end of the pinion shaft drives a large ring gear the axis of rotation of which is 90° away from the pinion. The pinion and gear reduce the gear ratio of the axle, and change the direction of rotation to turn the axle shafts which drive both wheels. The rear axle gear ratio is found by dividing the number of pinion gear teeth into the number of ring gear teeth.
The ring gear drives the differential case. The case provides the two mounting points for the ends of a pinion shaft on which are mounted two pinion gears. The pinion gears drive the two side gears, one of which is located on the inner end of each axle shaft.
By driving the axle shafts through the arrangement, the differential allows the outer drive wheel to turn faster than the inner drive wheel in a turn.
The main drive pinion and the side bearings, which bear the weight of the differential case, are shimmed to provide proper bearing preload, and to position the pinion and ring gears properly.
The proper adjustment of the relationship of the ring and pinion gears is critical. It should be attempted only by those with extensive equipment and/or experience.
Limited-slip differentials include clutches which tend to link each axle shaft to the differential case. Clutches may be engaged either by spring action or by pressure produced by the torque on the axles during a turn. During turning on a dry pavement, the effects of the clutches are overcome, and each wheel turns at the required speed. When slippage occurs at either wheel, however, the clutches will transmit some of the power to the wheel which has the greater amount of traction. Because of the presence of clutches, limited-slip units require a special lubricant.