Volvo Truck 2003-05

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    Read out the programmed data before replacing the climate control module. This is done in VIDA vehicle communication. After replacing the Climate Control Module (CCM), the relevant parameters must be programmed.

  2.  
  3. Move the gear selector/gear selector lever to the rearmost position.
  4.  
  5. Turn the ignition to the OFF position.
  6.  
  7. Remove the ignition key. The key must be removed to ensure that the ignition is not switched on by mistake.
    WARNING
    After the key has been removed, wait three minutes before starting work.

  8.  
  9. Detach the panel at the gear selector lever as illustrated.

    Click image to see an enlarged view

    Fig. Detaching gear shift panel

    Detaching gear shift panel
  10.  
  11. Twist the panel so that it is as far from the center console as possible.
  12.  
  13. Remove the lower screws from the bracket.
  14.  
  15. Angle out the entire Infotainment Control Module (ICM) and the dashboard environment panel as illustrated.

    Click image to see an enlarged view

    Fig. Disconnecting the dashbaoard environment panel

    Disconnecting the dashbaoard environment panel
  16.  
  17. Disconnect the electrical connections.
  18.  
  19. Turn over the ICM with the dashboard environment panel and remove the four screws as illustrated.

    Click image to see an enlarged view

    Fig. Disconnecting the ICM from the control panel

    Disconnecting the ICM from the control panel
  20.  
  21. Press the four clips and remove the control panel by pulling it straight out.
  22.  

To install:

  1. Install or connect the following:
    NOTE
    After replacing the climate control module (CCM), the module will require reprogramming.



    Install the control panel by pushing it into the four clips
     
    The ICM panel so that it hooks into the dashboard environment panel.
     
    The four screws
     
    The electrical connectors
     
    Angle the upper section of the ICM into place. Then screw the lower edge into place using the two lower screws.
     
    The panel at the gear selector lever
     
    The negative battery cable
     

  2.  
  3. Reprogram the customer programmed data.
  4.  
  5. Carry out self-adjustment of the blend door actuator positions. This is done in VIDA vehicle communication.
  6.  
  7. Test drive the vehicle. Check that the engine and climate control systems are functioning.
  8.  

 
label.common.footer.alt.autozoneLogo