Removal & Installation
- Before servicing the vehicle, refer to the Precautions Section.
- Raise the vehicle.
Remove or disconnect the following:
Install or connect the following:
The control arm rail (5742-1) in the control arm
- Raise the control arms to their normal position using the tensioner 999 5659
Tighten the M12 bolt for the inner mounting for the control arm. Tighten to 59 ft. lbs. (80 Nm).
NOTEIf the vehicle is equipped with Bi-Xenon lamps, the position sensor must be calibrated. Carry out calibration according to VIDA Vehicle communication (Function area 3, Electrical system, Rear electronic module).