Vue 2002-2005

Slave (Actuator) Cylinder

Print

Removal & Installation



Before servicing any vehicle, please be sure to read the precautions section, which deals with personal safety, prevention of component damage, and important points to take into consideration when servicing a motor vehicle.

  1. Disconnect the clutch master cylinder line from the transaxle by removing the C-clip.
  2.  
  3. Remove the transaxle.
  4.  
  5. Remove the clutch actuator cylinder bolts from the transaxle.
  6.  
  7. Remove the clutch actuator cylinder.
  8.  

To install:


NOTE
Excessive amounts of lubricant on the input shaft splines can contaminate the clutch disc and cause clutch shudder.

  1. Lightly lubricate the inside diameter of the bearing with input shaft lubricant P/N 21005995 or equivalent.
  2.  
  3. Install the clutch actuator cylinder (1) to the transaxle.

    Click image to see an enlarged view

    Fig. Install the clutch actuator cylinder (1) to the transaxle

  4.  
  5. Install the clutch actuator cylinder bolts.
  6.  
  7. Tighten the bolts to 89 inch lbs. (10 Nm).
  8.  
  9. Install the transaxle.
  10.  
  11. Connect the clutch master cylinder line to the transaxle by pushing it in until it seats.
  12.  
  13. Bleed the clutch hydraulic system.
  14.  

Before servicing any vehicle, please be sure to read the precautions section, which deals with personal safety, prevention of component damage, and important points to take into consideration when servicing a motor vehicle.

  1. Disconnect the clutch master cylinder line from the transaxle by removing the C-clip.
  2.  
  3. Remove the transaxle.
  4.  
  5. Remove the clutch actuator cylinder bolts from the transaxle.
  6.  
  7. Remove the clutch actuator cylinder.
  8.  

To install:


NOTE
Excessive amounts of lubricant on the input shaft splines can contaminate the clutch disc and cause clutch shudder.

  1. Lightly lubricate the inside diameter of the bearing with input shaft lubricant P/N 21005995 or equivalent.
  2.  
  3. Install the clutch actuator cylinder (1) to the transaxle.

    Click image to see an enlarged view

    Fig. Install the clutch actuator cylinder (1) to the transaxle

  4.  
  5. Install the clutch actuator cylinder bolts.
  6.  
  7. Tighten the bolts to 89 inch lbs. (10 Nm).
  8.  
  9. Install the transaxle.
  10.  
  11. Connect the clutch master cylinder line to the transaxle by pushing it in until it seats.
  12.  
  13. Bleed the clutch hydraulic system.
  14.  

 
label.common.footer.alt.autozoneLogo