Vue 2002-2005

Multi-Function (Combination) Switch

Print

Removal & Installataion



Before servicing any vehicle, please be sure to read the precautions section, which deals with personal safety, prevention of component damage, and important points to take into consideration when servicing a motor vehicle.

  1. Disable the SIR (air bag) system, as outlined in the Chassis Electrical Section.
  2.  
  3. Remove the upper to lower steering column cover fasteners.
  4.  
  5. Unsnap and remove the upper steering column cover.
  6.  
  7. Remove the lower steering column cover screws.

    Click image to see an enlarged view

    Fig. Remove the lower steering column cover screws

  8.  
  9. Unsnap and remove the ignition switch bezel.
  10.  
  11. Remove the lower trim cover.
  12.  
  13. Disconnect the multifunction turn signal switch harness connectors.
  14.  
  15. Depress the lock tabs on the left and right multifunction levers.
  16.  
  17. Remove the multifunction levers.
  18.  

To install:

  1. Install the multifunction turn signal switch to the steering column.
    NOTE
    Ensure both locking tabs are seated.

  2.  
  3. Connect the multifunction turn signal switch harness connectors.
  4.  
  5. Position the upper and lower shrouds.
  6.  
  7. Apply light pressure until they snap in place.
  8.  
  9. Install the ignition switch bezel.
  10.  
  11. Install the steering column fasteners.
  12.  
  13. Tighten the lower steering column cover screws to 18 inch lbs. (2 Nm).
  14.  
  15. Enable the SIR system.
  16.  

Before servicing any vehicle, please be sure to read the precautions section, which deals with personal safety, prevention of component damage, and important points to take into consideration when servicing a motor vehicle.

  1. Disable the SIR (air bag) system. Refer to Air Bag (Supplemental Restraint System), disarming the system.
  2.  
  3. Remove the upper to lower steering column cover fasteners.
  4.  
  5. Unsnap and remove the upper steering column cover.
  6.  
  7. Remove the lower steering column cover screws.

    Click image to see an enlarged view

    Fig. Remove the lower steering column cover screws

  8.  
  9. Unsnap and remove the ignition switch bezel.
  10.  
  11. Remove the lower trim cover.
  12.  
  13. Disconnect the multifunction turn signal switch harness connectors.
  14.  
  15. Depress the lock tabs on the left and right multifunction levers.
  16.  
  17. Remove the multifunction levers.
  18.  

To install:

  1. Install the multifunction turn signal switch to the steering column.
    NOTE
    Ensure both locking tabs are seated.

  2.  
  3. Connect the multifunction turn signal switch harness connectors.
  4.  
  5. Position the upper and lower shrouds.
  6.  
  7. Apply light pressure until they snap in place.
  8.  
  9. Install the ignition switch bezel.
  10.  
  11. Install the steering column fasteners.
  12.  
  13. Tighten the lower steering column cover screws to 18 inch lbs. (2 Nm).
  14.  
  15. Enable the SIR system. Refer to Air Bag (Supplemental Restraint System), arming the system.
  16.  

 
label.common.footer.alt.autozoneLogo