Vue 2006-2007

Windshield Wiper Systems

Print

Removal & Installation



Wiper Motor
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the wiper arms.
  4.  
  5. Remove the air inlet grille panels.
  6.  
  7. Remove the windshield wiper module bolts (1).
  8.  
  9. Disconnect the windshield wiper motor electrical connector (2).
  10.  
  11. Raise the rearward edge of the windshield washer module assembly (3) out of the plenum panel.
  12.  
  13. Remove the wiper motor to crank nut.
  14.  
  15. Remove the two wiper motor to wiper module frame bolts.
  16.  
  17. Remove the wiper motor from the wiper module.

    Click image to see an enlarged view

    Fig. Expanded view of the windshield wiper motor module

  18.  

To install:

  1. Position the wiper motor to the wiper module.
  2.  
  3. Install the two wiper motor to wiper module frame bolts. Tighten the bolts to 71 inch lbs. (8 Nm).
  4.  
  5. Install the wiper motor crank arm and crank arm nut. Tighten the screws to 10 ft. lbs. (14 Nm).
    NOTE
    Connect the electrical connector to the wiper motor and the harness rose bud to the wiper module frame prior to installing the module assembly back into the plenum.

  6.  
  7. Connect the electrical connector to the wiper motor.
  8.  
  9. Place the rearward edge of the windshield washer module assembly (3) into the plenum panel.
  10.  
  11. Install the windshield wiper module bolts (1). Tighten bolts to 80 inch lbs. (9 Nm) in sequence as shown.
  12.  
  13. Install the air inlet grille panels.
  14.  
  15. Install the wiper arms.
  16.  

 
label.common.footer.alt.autozoneLogo