Yaris 2007

Exterior Lighting

Print

Back-up, Brake, Marker, Signal, & Tail Lights



Removal & Installation
Tail Lights
Assembly
Hatchback

Specific to:

Toyota Yaris 2007-2010

  1. Disconnect the negative battery cable.
  2.  
  3. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the rear combination light cover.
  4.  
  5. Remove rear combination light assembly:
    1. Remove the 2 nuts.
    2.  
    3. Disconnect the connector.
    4.  
    5. Slide the tail light (rear combination light) toward the rear of the vehicle.
      NOTE
      Do not touch the bulbs with your fingers.

    6.  

  6.  
  7. To install, reverse the removal procedure.

    Click image to see an enlarged view

    Fig. Rear taillight assembly and components-Hatchback

  8.  

Sedan

Specific to:

Toyota Yaris 2007-2010

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the luggage compartment floor mat.
  4.  
  5. Remove the spare wheel cover assembly.
  6.  
  7. Remove the deck floor box with the deck side box door.
  8.  
  9. Disengage the 2 clips and the rear floor finish plate.
  10.  
  11. Disengage the 5 clips and remove the luggage compartment trim inner cover.
  12.  
  13. Remove rear combination light assembly:
    1. Remove the 2 nuts.
    2.  
    3. Disconnect the connector.
    4.  
    5. Slide the rear combination light assembly toward the rear of the vehicle.
    6.  

  14.  
  15. To install, reverse the removal procedure.

    Click image to see an enlarged view

    Fig. Rear taillight assembly and components-Sedan

  16.  

Bulb
Hatchback

Specific to:

Toyota Yaris 2007-2010

  1. Disengage the fitting of the rib.
  2.  
  3. Disengage the claw on the upper side, then on the lower side.
  4.  
  5. Turn the 2 rear combination light bulb counterclockwise and upwards to remove them.
  6.  
  7. Turn the rear combination light socket and wire counterclockwise to remove them.
  8.  
  9. Remove the rear combination light bulb from the socket and wire.
  10.  
  11. Disconnect the connector and remove the rear combination light socket and wire.
    NOTE
    Do not touch the bulbs with your fingers.

  12.  
  13. To install, reverse the removal procedure.

    Click image to see an enlarged view

    Fig. Rear taillight assembly and components-Hatchback

  14.  

Sedan

Specific to:

Toyota Yaris 2007-2010

  1. Remove tail light and stop light bulb:
    1. Turn the tail light and stop light bulb socket and bulb counterclockwise.
    2.  
    3. Remove the tail light and stop light bulb from the light socket.
    4.  

  2.  
  3. Remove turn signal light bulb:
    1. Turn the turn signal light bulb socket and bulb counterclockwise.
    2.  
    3. Remove the turn signal light bulb from the light socket.
    4.  

  4.  
  5. Remove backup light bulb:
    1. Turn the backup light bulb socket and bulb counterclockwise.
    2.  
    3. Remove the backup light bulb from the light socket.
      NOTE
      Do not touch the bulbs with your fingers.

    4.  

  6.  
  7. To install, reverse the removal procedure.

    Click image to see an enlarged view

    Fig. Rear taillight bulb and assembly

  8.  

Headlights



Removal & Installation
Assembly
Hatchback

Specific to:

Toyota Yaris 2007-2010

  1. Disconnect the negative battery cable.
    NOTE
    If equipped with fog lights, disconnect the connectors.

  2.  
  3. Remove the front bumper:
    1. Remove the 8 screws.
    2.  
    3. Remove the 2 screw grommets.
    4.  
    5. Remove the 7 clips.
    6.  
    7. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
    8.  
    9. Disconnect the 2 connectors.
    10.  
    11. Remove the 2 clips and the screw grommet.

      Click image to see an enlarged view

      Fig. View of the front bumper and components-Hatchback

    12.  

  4.  
  5. Remove headlight assembly:
    1. Remove the 3 screws.
    2.  
    3. Disconnect the 3 connectors, then remove the headlight.
      NOTE
      Do not touch the bulbs with your fingers.



      Click image to see an enlarged view

      Fig. Headlight assembly and components-Hatchback

    4.  

  6.  
  7. To install, reverse the removal procedure.
  8.  

Sedan

Specific to:

Toyota Yaris 2007-2010

  1. Disconnect the negative battery cable.
    NOTE
    If equipped with fog lights, disconnect the connectors.

  2.  
  3. If equipped with a small front spoiler:
    1. Remove the 2 screws, the 10 bolts and the front spoiler cover.
    2.  

  4.  
  5. Remove front bumper cover (with large front spoiler):
    1. Remove the 9 bolts and the 7 screws.
    2.  
    3. Remove the 2 screw grommets.
    4.  
    5. Remove the 6 clips.
    6.  
    7. Disengage the 6 claws and remove the front bumper cover.
    8.  
    9. Remove the 2 clips, the screw grommet and the 6 spring nuts.
    10.  

  6.  
  7. Remove front bumper cover (with small front spoiler):
    1. Remove the 5 screws and the 3 bolts.
    2.  
    3. Remove the 2 screw grommets.
    4.  
    5. Remove the 6 clips.
    6.  
    7. Disengage the 6 claws and remove the front bumper cover.
    8.  
    9. Disconnect the connectors.
    10.  
    11. Remove the 2 clips, the screw grommet and the 10 spring nuts.
    12.  

  8.  
  9. Remove front bumper cover (without front spoiler):
    1. Remove the 7 screws and the 3 bolts.
    2.  
    3. Remove the 2 screw grommets.
    4.  
    5. Remove the 6 clips.
    6.  
    7. Disengage the 6 claws and remove the front bumper cover.
    8.  
    9. Disconnect the connectors.
    10.  
    11. Remove the 2 clips and the screw grommet.

      Click image to see an enlarged view

      Fig. View of the front bumper and components-Sedan

    12.  

  10.  
  11. Remove the headlight assembly:
    1. Remove the 2 screws and the bolt.
    2.  
    3. Disconnect the 2 connectors, then remove the headlight.
      NOTE
      Do not touch the bulbs with your fingers.

    4.  

  12.  
  13. To install, reverse the removal procedure.

    Click image to see an enlarged view

    Fig. Headlight assembly and components-Sedan

  14.  

Bulb
Hatchback

Specific to:

Toyota Yaris 2007-2010

  1. Remove headlight bulb:
    1. Remove the socket cover.
    2.  
    3. Push the set spring, and pull it in the direction indicated by the arrows in the illustration, to disengage it.

      Click image to see an enlarged view

      Fig. Push the set spring, and pull it in the direction indicated by the arrows

    4.  
    5. Remove the headlight bulb.
    6.  

  2.  
  3. Remove clearance light bulb:
    1. Turn the clearance light bulb socket and bulb counterclockwise to remove them.
    2.  
    3. Remove the clearance light bulb from the light socket.
    4.  

  4.  
  5. Remove front turn signal light bulb:
    1. Turn the front turn signal light socket and bulb counterclockwise to remove them.
    2.  
    3. Remove the front turn signal light bulb from the light socket.
    4.  

  6.  
  7. Remove parking light bulb:
    1. Turn the parking light socket and bulb counterclockwise to remove them.
    2.  
    3. Remove the parking light bulb from the light socket.
      NOTE
      Do not touch the bulbs with your fingers.

    4.  

  8.  
  9. To install, reverse the removal procedure.

    Click image to see an enlarged view

    Fig. Headlight assembly and components-Hatchback

  10.  

Sedan

Specific to:

Toyota Yaris 2007-2010

  1. Remove headlight no.1 bulb:
    1. Remove the socket cover.
    2.  
    3. Push the set spring, and pull it in the directions indicated by the arrow in the illustration, to disengage it.
    4.  
    5. Remove the headlight No. 1 bulb.

      Click image to see an enlarged view

      Fig. the set spring, and pull it in the directions indicated by the arrow

    6.  

  2.  
  3. Remove front turn signal and parking light bulb:
    1. Turn the front turn signal and parking light socket and bulb counterclockwise to remove them.
    2.  
    3. Remove the front turn signal and parking light bulb from the light socket.
    4.  

  4.  
  5. Remove side marker light bulb:
    1. Turn the side marker light socket and bulb counterclockwise to remove them.
    2.  
    3. Remove the side marker light bulb from the light socket.
      NOTE
      Do not touch the bulbs with your fingers.

    4.  

  6.  
  7. To install, reverse the removal procedure.

    Click image to see an enlarged view

    Fig. Headlight assembly and components-Sedan

  8.  

 
label.common.footer.alt.autozoneLogo