Yaris 2007

Wheel Hubs & Bearings

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove rear wheel.
  4.  
  5. Remove rear brake drum sub-assembly.
  6.  
  7. Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.
    NOTE
    Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.

  8.  
  9. Remove the 4 bolts and remove the axle hub and bearing from the axle beam.
    NOTE
    Suspend the backing plate with a piece of rope.



    Click image to see an enlarged view

    Fig. Locating the 4 bolts and remove the axle hub and bearing from the axle beam

  10.  

To install:

  1. Install the axle hub and bearing onto the axle beam with the 4 bolts. Tighten to 67 ft. lbs. (90 Nm).
  2.  
  3. Inspect rear axle hub bearing.
  4.  
  5. To complete the installation, reverse the remaining removal procedure.
  6.  

 
label.common.footer.alt.autozoneLogo