eseries van 2006-2007

Ignition Lock Cylinder


Removal & Installation

  1. Disconnect the negative battery cable.
  3. Position the lock cylinder to RUN.
  5. Using a suitable tool, push upward on the cylinder release tab through the hole in the lower shroud while pulling the cylinder outward.

    Click image to see an enlarged view

    Fig. Position the key to the RUN position (1) and pushed upward on the tab while pulling the cylinder outward (2)-E-Series Models


To install:

  1. Install the ignition switch lock cylinder by turning it to the RUN position. Insert the ignition switch lock cylinder into the steering column housing. Make sure the ignition switch lock cylinder is fully seated and aligned in the interlocking washer before turning the key to the OFF position. This will permit the retaining pin of the ignition switch lock cylinder to extend into the hole of the steering column.
  3. Rotate the ignition switch lock cylinder, using the key, to ensure correct mechanical operation in all positions.
  5. Connect the negative battery cable.