tC 2007

Slave (Release) Cylinder

Print

Removal & Installation



  1. Disconnect the clutch release (slave) cylinder-to-flexible hose tube, using SST 09023-00101, or equivalent tool.
    NOTE
    Use a container or rag to catch any fluid that may leak out.



    Click image to see an enlarged view

    Fig. Disconnect the clutch release (slave) cylinder-to-flexible hose tube, using SST 09023-00101, or equivalent tool

  2.  
  3. Remove the 3 bolts, then remove the release (slave) cylinder.

    Click image to see an enlarged view

    Fig. Unfasten the 3 bolts, then remove the release (slave) cylinder

  4.  

To install:

  1. Install the release (slave) cylinder with the 3 bolts. Tighten the 2 mounting bolts to 9 ft. lbs. (12 Nm) and the fluid line bolt to 13 ft. lbs. (18 Nm).
  2.  
  3. Connect the clutch release cylinder-to-flexible hose tube using the special tool. Tighten to 11 ft. lbs. (15 Nm).
  4.  
  5. Fill the fluid reservoir tank with brake fluid and bleed the clutch system, as outlined in this section.
  6.  
  7. Check for any clutch fluid leakage
  8.  

 
label.common.footer.alt.autozoneLogo