tC 2007

Removal & Installation

Print

Specific to:

Scion tC 2007-2008

Scion xB 2008

Scion xD 2008

  1. Raise and safely support the vehicle.
  2.  
  3. Remove the right front wheel and tire assembly.
  4.  
  5. Drain the power steering fluid into a suitable container.
  6.  
  7. Remove the front right fender apron seal.
  8.  
  9. Remove the fan-alternator belt, as outlined in the Engine Mechanical Section.
  10.  
  11. Remove the clip and disconnect the oil reservoir to pump hose no.1.
    WARNING
    Do not spill fluid on the belt.

  12.  
  13. Disconnect the pressure feed tube as follows:
    1. Remove the bolt and separate the pressure feed tube from the pump bracket rear.
    2.  
    3. Using a wrench (27 mm) to hold the pressure port union, remove the union bolt and gasket.
    4.  

  14.  
  15. Remove the power steering pump as follows:
    1. Disconnect the connector from the oil pressure switch.
    2.  
    3. Using SST 09249-63010, or equivalent, and a deep socket (14 mm), loosen the 2 bolts.
    4.  
    5. Remove the power steering pump assembly.

      Click image to see an enlarged view

      Fig. Using the special tool and a deep socket (14 mm), loosen the 2 bolts, then remove the power steering pump

    6.  

  16.  

To install:

  1. Install the power steering pump as follows:
    1. Temporarily install the 2 bolts to the power steering pump assembly.
    2.  
    3. Install the power steering pump with the 2 bolts.
    4.  
    5. Using SST 09249-63010, or equivalent, and a deep socket (14 mm), fully tighten the bolts. To 25 ft. lbs. (34 Nm).
      NOTE
      Use a torque wrench with a fulcrum length of 300 mm (11.81 in.). This torque value is effective when the special tool is parallel to the torque wrench.



      Click image to see an enlarged view

      Fig. Using SST 09249-63010, or equivalent, and a deep socket (14 mm), fully tighten the bolts. To 25 ft. lbs. (34 Nm). Use a torque wrench with a fulcrum length of 300 mm (11.81 in.). This torque value is effective when the special tool is parallel to the torque wrench

    6.  
    7. Attach the connector to the oil pressure switch.
    8.  

  2.  
  3. Connect the pressure feed tube as follows:
    1. Install the pressure feed tube and a new gasket to the power steering pump with the union bolt.
      NOTE
      Make sure the stopper of the pressure feed tube touches the power steering pump body.

    2.  
    3. Using a 27mm wrench to hold the pressure port union, tighten the union bolt to 38 ft. lbs. (52 Nm).
    4.  

  4.  
  5. Install the pressure feed tube with the bolt to the rear pump bracket and tighten to 69 inch lbs. (7.8 Nm).
  6.  
  7. Connect the oil reservoir to pump hose no.1 with the clip.
    WARNING
    Do not spill fluid on the belt.

  8.  
  9. Install the fan-alternator belt, as outlined in the Engine Mechanical Section.
  10.  
  11. Install the front fender apron seal and front wheel and tire.
  12.  
  13. Add power steering fluid and bleed the system, as outlined in this section.
  14.  
  15. Check for fluid leaks.
  16.  

 
label.common.footer.alt.autozoneLogo