tC 2007

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Drain the cooling system.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Right-hand front fender apron
     
    Engine undercover
     
    Accessory drive belt
     
    Alternator
     

  6.  
  7. Using Special Tool 09960-10010, remove the water pump pulley.

    Click image to see an enlarged view

    Fig. Use Special Tool 09960-10010 to hold the water pump pulley while removing the mounting bolts.

  8.  
  9. Remove the water pump assembly.
  10.  

To install:

  1. Install the water pump with a new gasket. Tighten to 80 inch lbs. (9 Nm).
  2.  
  3. Using Special Tool 09960-10010, install the water pump pulley and tighten to 19 ft. lbs. (26 Nm).
  4.  
  5. Install or connect the following:

    Alternator
     
    Accessory drive belt
     
    Engine undercover
     
    Right-hand front fender apron
     
    Negative battery cable
     

  6.  
  7. Refill the engine cooling system to the correct level.
  8.  
  9. Start the engine and check for leaks.
  10.  

 
label.common.footer.alt.autozoneLogo