Log In
Search suggestions

    My Vehicles

    1984 Toyota Truck Pickup 2WD 2.4L 2BL 4cyl

    My Store

    405 N COLLEGE ST
    (479) 443-4043

    OPEN 'til 10:00 PM today

    SAVE 20% ON ONLINE SHIP-TO-HOME ORDERS OF $100 OR MORE.

    Use Code: SEECLEAR

    See Details

    Choke Pulloff

    Inspect/Test/Replace

    If the choke plate is not opening when the engine starts, check for a vacuum leak in the choke qualifying mechanism. If a diaphragm vacuum break is used, look for a cracked vacuum hose or loose hose connections.

    To check the diaphragm:

    • Remove the vacuum hose, and install a vacuum pump.
    • Apply vacuum to the pump diaphragm.
    • If the diaphragm does not hold vacuum or if the vacuum leaks down faster than the manufacturer specifies, the vacuum break should be replaced.
      Adjusting the fast idle cam.

    If the carburetor has a secondary vacuum break:

    • Test the thermal vacuum valve or choke vacuum thermal switch.
    • Consult the manufacturer's service manual for temperature specifications.
    • Connect a vacuum pump to the lower port and a vacuum gauge to the upper port.
    • Apply the specified vacuum and alternately warm and cool the valve or switch. The valve should permit vacuum passage when the valve is warm and block vacuum when the valve is cold. If the engine runs rough immediately after start-up, the choke might not be opening the specified amount.
    • To check the qualifying dimension: Apply the specified vacuum to the diaphragm using a vacuum pump. Measure the clearance between the upper edge of the choke plate and the air horn wall using a drill bit with a diameter equal to the specified dimension.
    • To adjust the dimension, bend the choke linkage with a pair of pliers. Operation of the heating element is checked with a digital volt-ohmmeter.
    • Refer to the manufacturer's service manual for procedures and specifications.
    • Before making any adjustments on the choke, move its linkage by hand to be certain there is no binding or sticking in the linkage, shaft, or choke plate.
    • Use an approved carburetor cleaner to remove any gum deposits that interfere with its operation.
    • If the choke housing permits adjustment of the choke setting, the choke can be adjusted to enrich or lean the air/fuel mixture

    AutoZone Logo