Quick Boot - CV

Inspect/Replace

To check the condition of the boots:

  • Look for splits, cracks, tears, punctures, or thin spots caused by rubbing. These call for immediate boot replacement.
    • Tears in the boot are an obvious sign of failure requiring that extra care be taken when cleaning and greasing the boot during replacement.
    • Small cracks in the rubber or collapsed bellows that allow the boot to rub on moving parts or the joint are early signs the boot will fail.
  • If the boot appears rotted, this indicates improper greasing or excessive heat, and it should be replaced.
  • Squeeze all boots. If any air escapes, replace the boot.
  • If the inner boot appears to be collapsed or deformed, venting it (allowing air to enter) might solve the problem.
  • Place a round-tipped rod between the boot and drive shaft.
  • This equalizes the outside and inside air and allows the boot to return to its normal shape.
  • Make sure that all boot clamps are tight.
  • Missing or loose clamps should be replaced.
  • If the boot appears loose, slide it back and inspect the grease inside for possible contamination.
    • A milky or foamy appearance indicates water contamination.
    • A gritty feeling when rubbed between the fingers indicates dirt.
  • In most cases, a water- or dirt-contaminated joint should be replaced.
Pivot points sealed with rubber boots. Courtesy of Chrysler Corporation.

label.common.footer.alt.autozoneLogo