Log In
Search suggestions

    My Vehicles

    2006 GMC Truck Sierra 1500HD 4WD 6.0L SFI 8cyl

    My Store

    9920 PARAMOUNT BLV
    (562) 776-3393

    CLOSED Open at 7:30 AM

    GET A $25 GIFT CARD FOR EVERY $100 SPENT ON ONLINE SHIP-TO-HOME ORDERS.

    Use Code: GIFTME

    See Details

    Carrier Bearing

    Inspect/Replace

    • Remove the driveshafts.
    • On a two-piece driveshaft, a center support bearing is used to hold the center of the shaft where the two shafts attach to each other. It bolts to the frame, cross member or underside of the vehicle. The sealed bearing is supported in a rubber mount that dampens noise and vibration.
    A center bearing assembly.
    • The bearing is pressed off and a new one is pressed on.
    • If the two pieces of the driveshaft are separated, be sure that they are reassembled in phase. Assembling the front and rear halves out of phase can cause extreme vibration. When the shafts are not marked before disassembly, use a tape measure or a steel rod to check the alignment of the halves.

    AutoZone Logo