Log In
Search suggestions

    My Vehicles

    2007 Volvo S60R AWD 2.5L Turbo DOHC 5cyl

    My Store

    405 N COLLEGE ST
    (479) 443-4043

    OPEN 'til 9:00 PM today

    GET A $25 GIFT CARD FOR EVERY $100 SPENT ON ONLINE SHIP-TO-HOME ORDERS.

    Use Code: GIFTME

    See Details

    Honda - Accord Prelude 1996 2000

    Slave Cylinder

    Print

    REMOVAL & INSTALLATION





    Click image to see an enlarged view

    Fig. The slave cylinder (B) is mounted to the transaxle with retaining bolts (A & C)-Accord shown



    Click image to see an enlarged view

    Fig. Installed view of the slave cylinder-Prelude shown

    1. Locate the slave cylinder mounted on the transaxle assembly, near the radiator.
    2.  
    3. Remove the flare fitting and steel line from the slave cylinder assembly.
    4.  
    5. Remove the slave cylinder from the clutch housing by removing the attaching bolts.
    6.  
    7. Installation is the reverse of the removal procedure
    8.  

    Use only fresh DOT 3 or 4 brake fluid from a sealed container to refill the clutch hydraulic system.

    1. Fill, then bleed the clutch system, using a suitable DOT 3 or 4 brake fluid.
    2.  

    HYDRAULIC SYSTEM BLEEDING



    Use only DOT 3 or 4 brake fluid from a clean, sealed container, for the clutch master reservoir. As brake fluid will damage the vehicle's paint, clean up any spills immediately.

    1. Use a suitable siphon or a clean turkey baster to remove the old brake fluid, or remove the clutch master cylinder reservoir bracket mounting bolts and pour the old fluid into a suitable container.
    2.  
    3. If removed, install the clutch master cylinder fluid reservoir and fill it the MAX line with suitable DOT 3 or 4 brake fluid from a fresh, sealed container.
    4.  
    5. Clean the reservoir thoroughly using a clean shop cloth or paper towel.
    6.  
    7. Fit a flare or box end wrench onto the slave cylinder bleeder screw.
    8.  
    9. Attach a (clear if available) rubber tube to the slave cylinder bleed screw and suspend it into a suitable clear drain container partially filled with brake fluid.
    10.  
    11. Make sure the clutch master cylinder is filled with brake fluid.
    12.  
    13. Open the bleeder screw and have an assistant press the clutch pedal to the floor.
    14.  
    15. While holding the clutch pedal to the floor, close the bleed screw.
    16.  
    17. Slowly release the clutch pedal to its fullest extension and recheck the reservoir fluid level. Top off as necessary.
    18.  
    19. Repeat the above steps until the fluid exiting the bleed screw is clean and free of all air bubbles.
    20.  
    21. Top off the clutch master cylinder reservoir as necessary.
    22.  

     
    AutoZone Logo