Log In
Search suggestions

    My Vehicles

    2011 Lincoln Town Car Executive L 4.6L Flex Fuel SOHC 8cyl

    My Store

    1720 S RIDGEWOOD A
    (386) 427-1210

    CLOSED Open at 7:30 AM

    Save 20% On Orders Over $100

    Use Code: HOLIDAY20

    See Details

    Get A $25 AutoZone Gift Card

    Use Code: HOLIDAY25

    See Details

    Jeep Wrangler/YJ 1987-1995 Repair Guide

    Blower Motor

    Print

    REMOVAL & INSTALLATION



    Without Air Conditioning

    See Figures 1, 2 and 3



    Click image to see an enlarged view

    Fig. Fig. 1: Heating system components



    Click image to see an enlarged view

    Fig. Fig. 2: Remove the blower motor-to-heater housing cover screws



    Click image to see an enlarged view

    Fig. Fig. 3: After removing the retaining screws the blower motor can be separated from the heater housing

    The heater housing assembly must be removed in order to get access the blower motor.

    1. Drain about two quarts of coolant.
    2.  


    CAUTION
    When draining coolant, keep in mind that cats and dogs are attracted by ethylene glycol antifreeze, and are quite likely to drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantity. Always drain the coolant into a sealable container. Coolant should be reused unless it is contaminated or several years old.

    1. Remove the heater housing assembly as outlined earlier in this section.
    2.  
    3. Remove the attaching screws and remove the blower motor.
    4.  

    To install:
    1. Install the blower motor into the housing, then tighten the attaching screws and nuts.
    2.  
    3. Install the heater housing as outlined earlier.
    4.  

    With Air Conditioning

    See Figure 4



    Click image to see an enlarged view

    Fig. Fig. 4: Evaporative housing and components

    It is not necessary to discharge the refrigerant system.

    1. Remove the hose clamps and dash grommet retaining screws.
    2.  
    3. Remove the evaporator housing-to-instrument panel retaining screws and the housing mounting bracket screw.
    4.  
    5. Remove the blower mounting screws and remove the blower. Disconnect the wiring.
    6.  
    7. Installation is the reverse of removal.
    8.  

     
    AutoZone Logo