Ford Ranger/Explorer/Mountaineer 1991-1999

Seats

Print

REMOVAL & INSTALLATION



Bench Seat

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Ranger bench seat

  1. On the right side, remove the seat track insulator.
  2.  
  3. Remove 4 seat track-to-floor retaining screws (2 each side) and lift the seat and track assembly from vehicle.
  4.  
  5. To remove the tracks from the seat, place the seat upside-down on a clean bench.
  6.  
  7. Disconnect the track latch tie rod assembly from latch lever and hook in the center of the cushion assembly.
  8.  
  9. Remove 4 track-to-seat cushion retaining screws (2 each side) and remove the tracks from the cushion assembly.
  10.  

To install:
  1. Position the track to the cushion assembly. Install the 4 track-to-seat retaining screws and tighten.
  2.  
  3. Connect the track latch tie rod assembly to the latch lever and hook in center of cushion.
  4.  
  5. Position the seat and track assembly in the vehicle.
  6.  
  7. Install the 4 seat track-to-floor retaining screws and tighten to specification.
  8.  
  9. On the right side, install the seat track insulator.
  10.  

Bucket and 60/40 Seats

See Figures 2, 3 and 4



Click image to see an enlarged view

Fig. Fig. 2: Ranger bucket seat



Click image to see an enlarged view

Fig. Fig. 3: Explorer/Mountaineer bucket seat



Click image to see an enlarged view

Fig. Fig. 4: 60/40 split seat-Explorer

  1. Remove the seat track insulator (Ranger passenger seat only).
  2.  
  3. Remove the 4 seat track-to-floorpan screws (2 each side) and lift the seat and track assembly from the vehicle.
  4.  
  5. To remove the seat tracks from the seat cushion, position the seat upside down on a clean bench.
  6.  
  7. Disconnect the latch tie rod assembly and assist spring from the tracks.
  8.  
  9. Remove 4 track-to-seat cushion screws (2 each side) from the track assemblies. Remove the tracks from seat cushion.
  10.  

To install:
  1. Position the tracks to the seat cushion. Install the 4 track-to-seat cushion screws (2 each side) and tighten.
  2.  
  3. Connect the latch tie rod assembly and assist spring to the tracks.
  4.  
  5. Position the seat and track assembly in the vehicle.
  6.  
  7. Install 4 track-to-floorpan screws and tighten to specification.
  8.  
  9. Install the seat track insulators (Ranger passenger seat only).
  10.  

 
AutoZone Logo