Ford Ranger AC Heater Blend Door Actuator

Buy Online. Pick Up In-Store.

1-6 of 6 Results

    1-6 of 6 Results

    Customer

    Reviews

    Reviews for


    IS NOT THE SAME AS THE OLD ONE

    Susan

    in 3 years

    If you look at the bottom the old one is flat and the new one has a half barrel shape doesn't allow for 4 tabs to come together. Not what is pictured on web sight

    What kind of vehicle do you drive? !996 Ford Ranger

    Reviews for


    Perfect fit for my 97 Ranger

    Jim

    in 10 months

    Perfect match for my vehicle. The old one was easy to remove - just pry it out with a flat-head screwdriver. The hard part was installing the new part - you have to line up the rod on the actuator with the orientation of the blend door; but you can't see how the door is oriented. What I did was, I plugged in the new actuator, started the truck, and turned the temp control to the hottest setting. I then stuck a long flat head screwdriver bit into the hole that the actuator rod goes into, and turned it all the way to the hottest orientation. I then removed the screwdriver bit, and the actuator rod then dropped right into the hole.

    What kind of vehicle do you drive? 1997 Ford Ranger XLT

    Reviews for


    It works.

    Joe

    in 2 years

    I installed this in a 2004 Ford Ranger Edge 3.0 V6. It was not easy to install but also not impossible. Unfortunately mine was screwed down and doesn't just snap on like I saw others did in a couple of YouTube videos. There is a screw at the back that was difficult to reach, even my small hands. I used a 1/4" ratchet with a 8mm socket that just barely reached back there. With alot of patience I was able to install it in about 30 minutes. Now my heater is working just fine.

    What kind of vehicle do you drive? 2004 Ford Ranger