MSD 8830 Noise Filter
  • Thumbnail  MSD 8830 Noise Filter

MSD 8830 Noise Filter

Part # 8830
SKU # 139779



Part #8830
SKU #139779
Maximum Current (A)10
Overall Height (in)2
Overall Width (in)2
Package ContentsNoise Filter, Cap, Mounting bracket, Mounting hardware
Installation Instructions IncludedYes
Installation Hardware IncludedYes
Color / FinishRed
MaterialMetal and Plastic
Overall Length (in)2


If you experience radio noise after installing the MSD Ignition, you may need to install an MSD noise filter. Electro magnetic interference (EMI) is occasionally generated from the MSD power cables and can be easily eliminated by installing the noise filter on the heavy power supply wires coming from the MSD. When the MSD draws current, it will draw through the noise filter instead of directly from the battery, so all other accessories that operate off 12 V, like the radio, fuel pump, or the engine computer, will be unaffected by the MSD. The noise filter will also prevent damage to the MSD during jump-starts and will keep a vehicle’s 12 Volt line clean by removing any voltage and current surges that could interfere with the operation of some MSD accessories such as the soft touch rev control or the two step module selector. It is recommended that the noise filter be used on installations with the MSD 7 and 8 series IGBT­timing to prevent this interference.

  • checkmarkEasy noise elimination
  • checkmarkDraws through noise filter
  • checkmarkOther accessories unaffected
  • checkmarkPrevent jump-start damage
  • checkmarkRemoves voltage/current surges
  • checkmarkRecommended w/7 and 8 series ignition