Toyota Corolla 1988-1997 Repair Guide

Radio/Tape Player Repair Guide

Print

REMOVAL & INSTALLATION



See Figures 1 and 2

  1. Disconnect the negative battery cable.
  2.  


CAUTION
On models with an airbag, wait at least 90 seconds from the time that the ignition switch is turned to the LOCK position and the battery is disconnected before performing any further work.

  1. Remove the attaching screws from the trim panel.
  2.  
  3. Remove the trim panel, being careful of the concealed spring clips behind the panel.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Remove the trim panel surrounding the stereo

  1. Disconnect the wiring from the switches if so equipped mounted in the trim panel.
  2.  
  3. Remove the mounting screws from the radio.
  4.  



Click image to see an enlarged view

Fig. Fig. 2: Remove the four radio retaining screws and pull the unit from the dash

  1. Remove the radio from the dash until the wiring connectors are exposed.
  2.  
  3. Disconnect the electrical connectors and the antenna cable from the body of the radio and remove the radio from the car.
  4.  

To install:
  1. Reconnect all the wiring and antenna cable first, then place the radio in position within the dash.
  2.  
  3. Install the attaching screws.
  4.  
  5. Reconnect the wiring harnesses to the switches if so equipped in the trim panel and make sure the switches if so equipped are secure in the panel.
  6.  
  7. Install the trim panel (make sure all the spring clips engage) and install the screws.
  8.  
  9. Connect the negative battery cable.
  10.  
  11. Check radio system for proper operation.
  12.  

 
AutoZone.com® ©2001- 2019  AutoZone, Inc. All Rights Reserved.