Steck Axle Popper II

The Antenna Wrench II works in conjunction with or independently the original Antenna Wrench (21600). It is tapered on both ends of the wedge along with a 6” shaft to fit into your air hammer. The base of the Axle Popper II has been increased by 3/8” to give it additional strength while decreasing potential deflection with the increased power of your air hammer. Safer than using a pry bar the Axle Popper II wedge forked end applies even pressure to both sides of the shaft for sure release of the shaft. Axle Popper Shim (71412), which is sold separately, can also be used with the Axle Popper II to fill the gap between the half shaft and the transaxle on some vehicles.

• 
  0
• 
  Tapered on both ends of the wedge along with a 6” shaft to fit into your air hammer
• 
  The base of the Axle Popper II has been increased by 3/8” to give it additional strength while decreasing potential deflection with the increased power of your air hammer
• 
  Safer than using a pry bar the Axle Popper II wedge forked end applies even pressure to both sides of the shaft for sure release of the shaft